Holden Cruze JG & JH 2009-2015 3 button flip key shell only - no electronics

Why replace your entire remote flip key just because the case or shell has broken away from the key blade. Here we offer you a top quality replacement for your Holden Cruze JG Series 3 button remote flip key shell. The Cruze JG was sold in Australia from 2009 - 2014 and the JH Cruze was sold 2011 - 2015.

THIS KEY IS MILLED OUT ALONG THE CENTRE OF THE BLADE AND MATCHES - SILCA HU100 OR JMA MLOP-11. 

As long as your remote control module still works, you can have the blade of this key cut to match your existing key and insert the remote module and transponder chip and you are up and running again.

If you come into our East Victoria Park shop we will be happy to cut the key, swap over your case and test your battery, while you wait. It is always best to have the car present when getting the key cut so it can be properly tested for smooth operation in doors and ignition. 

WE CHARGE $50 FOR THIS SERVICE TO BE DONE AT OUR SHOP

Please note that the dimensions shown under the DATA SHEET tab are of the flip key when the blade is folded in and should be used as a guide only.

If you do not live close by you can of course order this key shell and take it to your local key cutting shop and have them cut the blade to match your existing key. Then you can swap the remote module and transponder chip into the new shell and you are up and running.

Your original Holden flip key will be glued together and we have found these particular keys can be very tricky to get apart. You should take great care in taking the old shell apart to avoid damaging the circuit board or transponder chip. This shell features a screw through the back cover for added firmness once assembled.

We do advise that you use some contact glue around the edges of the shell when re-assembling it to ensure a firm fit. 

There are many cheap shells available online that may look similar, but this one here is made by JMA, who are one of the leading producers of key blanks in the world. This shell is made to a very high standard and the machining of the key blade is very accurate. We regularly have people bring in keys that they have purchased on eBay only to find that the blade is no machined to the correct dimensions or the circuit board does not fit well in the shell etc.

Even 0.01mm difference in the dimensions of the key blade can make it not fit correctly and so not work correctly when cut.

REF - MLOP-11.P7