Mongoose M60 Series N4096 Z333 3 button blue LED car alarm remote control MRC63B

This genuine Mongoose MRC63B 3 button car alarm remote works with a number of different M60 series car alarm, central locking or immobiliser systems made between 2009 and mid 2011. It operates on 303.9 MHz and has a BLUE LED.

Later model M60 systems made from mid 2011 were supplied with a similar remote control using a GREEN LED which operates on 433.9 MHz. 

The circuit board of this remote should have the following numbers printed on it - YF81OTW-2. The remote has no model number on the case and there are other very similar looking remotes on the market that are not the same so it is vital you check what system is fitted to your vehicle before purchasing this remote.

The back cover of the remote just has the N4096 Z333 compliance number on it.

If you do not have a working remote you will need to find your over-ride code from the owners manual.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing a button cell battery inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body, immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

Below you will see the coding instructions for the the M60 systems that this remote can be used with.

To learn new remotes to M60 models:

1. Disarm by existing remote, or use the override
2. Open the drivers door and leave open
3. Turn the ignition ON/OFF 3 times - siren chirps
4. Press arm button on first remote (siren chirps)
5. Press arm button on second remote (siren chirps)
6. Repeat for any other remotes
7. Wait 10 seconds for learning process to complete