Mongoose M33 Series N4096 Z333 3 button car alarm remote control MRC33

This genuine Mongoose MRC33 3 button car alarm remote works with a number of different Mongoose car alarm, central locking or immobiliser systems including the M33, MCL3000 and MCL3400 systems.

It operates on 433.9 MHz and has a BLUE LED.

THIS REMOTE LOOKS SIMILAR TO REMOTES USED WITH KIA & HYUNDAI CARS BUT IS NOT THE SAME

THIS REMOTE ALSO LOOKS SIMILAR TO A NUMBER OF GENERIC AFTERMARKET REMOTES - IT IS NOT THE SAME. CHECK THE PHOTOS OF THE CIRCUIT BOARD AND STICKERS FOUND INSIDE THIS REMOTE TO CONFIRM IT IS CORRECT FOR YOU.

The circuit board of this remote should have the following numbers printed on it - V788 - GM.

Underneath that you will see 2015.04.02 PCB1.0MM

The 8 leg IC chip on this remote is a HSC301 type chip.

Inside the back cover of the remote you will see a sticker with the numbers: N4096 Z333

The remote has no model number on the case and there are other very similar looking remotes on the market that are not the same so it is vital you check what system is fitted to your vehicle before purchasing this remote.

If you do not have a working remote you will need to find your over-ride button which will be fitted under the dash.

Below you will see the coding instructions for the the M33 systems that this remote can be used with.

To learn new remotes to M33 systems:

TO MEMORISE A NEW REMOTE:
a) Disarm the system using your working remote or the override method described on the below.
b) Turn the ignition from OFF to ON 3 times leaving it in the ON position on the third time. The siren will chirp.
c) Press the override switch for 5 seconds - siren chirps 3 times to confirm the system is in learning mode.
d) Press button 1 twice on 1st remote. Siren will chirp to confirm.
e) Press button 1 twice on 2nd remote. Siren will chirp to confirm.
Repeat this procedure if you have a third remote. Turn ignition off to complete the learning sequence.
Note: If you lose a remote, re-learning the existing remote will erase the one that is lost.

EMERGENCY OVERRIDE:

At the time of installation a hidden push button switch was fitted, usually under the dashboard.

If the alarm is armed and fails to respond to the remote control, or you have misplaced your remote, you can override the alarm as follows;

1) Open the door with the ignition key - the alarm will trigger
2) Turn on the ignition and press the override button for 3 seconds - this will cancel the alarm and put the alarm in valet mode – LED on constant. See below to cancel valet mode.

VALET MODE - LED PERMANENTLY LIT:

When disarmed, turn the ignition on and press and hold the override switch for 3 seconds. Siren will chirp and lights flash once to confirm. LED will stay lit to indicate valet mode.

Repeat this process to turn the system back on.