Audi 8P0837220D for Audi A3 TT 3 button ID48 434MHz KEYLESS GO remote flip key

This product has been temporarily removed from sale as direct result of the Consumer Goods (Products Containing Button/Coin Batteries) Safety Standard 2020 which becomes enforceable on 22nd June 2022 and carries fines of up to $1million. 

All products that contain a button cell or coin type battery must be safety tested to confirm they comply with these new regulations. All button cell batteries must be in a new type of packaging with new labels. 

We are working with all of our suppliers to confirm this compliance before we make the product available for sale again. 

We should have had 18 months to get this compliance but sadly the ACCC did not inform our suppliers or us or pretty much any other industry and we only found out about this new law 4 weeks ago.

Please feel free to email us with the details of what you were looking for and we will give you an update on when we expect it to be back available for sale.

Audi 8P0837220D compatible 3 button PROXIMITY remote flip key with an integrated ID 48 transponder chip on the circuit board and a 434 MHz remote control.

This keyless go proximity remote flip key suits the following models as long as your original key has the part number 8P0837220D as shown in the photos.

AUDI A3 06/2005 - 03/2013

AUDI S3 2006 - 2013

AUDI TT 2006 - 2014

As this is an aftermarket flip key the details printed on the shell will not match the details on a genuine key and should be ignored. The photos show the circuit board that comes inside this key and it is marked M0310 indicating that the key suits the models listed above and it has an ID48 transponder chip as part of the circuit board. 

This type of integrated transponder cannot be cloned and so it must be programmed to the vehicle using a diagnostic scan tool connected to the vehicle. We can program the new key to your car in our East Victoria Park workshop of you can have it cut and programmed by an automtive locksmith where you live.

Please call (08) 6110 2693 to book an appointment if you would like us to cut and program a key to your vehicle. We will generaly need the car for around 45 minutes to complete the job.

Please take care when opening the back of your remote to replace the battery as there is a small plastic tab on the back cover which uis veryu easily broken and so we advise you check out YouTube for instructions on how to safely open the back of the key and not damage this tab.

If the case of your original flip key is damaged but the remote works and the key still starts the car, you just need to replace the other casing, you can find this listed under Compatible Items.

Programming a spare key when there is a working key is far easier than trying to add a key when you have lost your only working key and so we strongly advise all customers to make sure they have a spare key for their vehicles.

HN REF: AU-RH-30B 03046