Airkey AKRX62-S standalone 2 relay output receiver for N series remotes

This standalone receiver made by AIRKEY suits the #N series of Airkey remotes. It is compact and has a large memory capacity with 340 memory slot capacity.

Specifications:
6 button input / 2 channel relay output
340 slot memory capacity
Compatible with Airkey Programmer & Airkey Manager
Operates with 2,4 & 6 button Airkey transmitters with #N serial numbers
Remote receiver learning functions
Operates from 12V-28V AC/DC

Power supply link (near heatsink):
To operate receiver on 12-28V AC or >12V DC, place power link on HV
To operate receiver on 12V battery, place power link on LV
(This will enable relays to continue operating with supply to 10V)

Remote learning header:
Remote learning is disabled by removing the 5 pin header
The header MUST be removed before connecting an Airkey Programmer or Airkey Manager or before
using the manual ADD or CLR buttons on the receiver

Clearing Receiver:
To clear ALL remotes, hold the CLR button until the Rc/OK LED turns on (Approx 5 sec)

Learning Airkeys directly ino Receiver:
To learn remotes directly into the receiver, hold ADD button** and press a button on each remote
in turn - Rx/OK LED will flash off as each remote is learned.
**Alternatively install link between pins 2 & 3 of ICSP header to learn a large batch of remotes

Remote learning:
The 5 pin header must be plugged into the ICSP header with pin 1 (bevel) towards
the centre of the receiver board (see main photo) to enable remote learning.

The header should be installed with the power off.
Alternatively, the header may be installed while the ADD button is held down.

Once header is in place you will need a learned remote that already operates the device.
Take that learned remote and press  buttons 1 & 2 together to activate learning mode.
Now press a button on the new remote within 3 seconds to learn it to the receiver.
N.B. Remote learning does not operate if using DURESS mode

CARE SHOULD BE TAKEN IF MORE THAN 1 RECEIVER ARE WITHIN RANGE AS THE REMOTE LEARNING
FUNCTION WILL OPERATE SIMULTANEOUSLY ON ALL RECEIVERS IN RANGE.

Minimum antenna:
Use 160mm length of 21AWG wire (Approx. 0.5mm)
For optimum reception the antenna should be straight, vertical and clear of any metalic objects.

Button relay Selections:
Various button & output combinations can be selected by insterting links at positions L1/L2/L3/L4/L5,
following the descriptions in the selection table which is supplied with the receiver. 

When following the Function selection Table please note that a 1 = closed or bridged link & 0 = open link

The relays can be set to:
Momentary Pulse,
Flipflop,
Momentary & flip/flop,
Hold Output (20 sec max)
Momentary & Hold
ON/OFF
Momentary & Short Timed
Momentary & Long Timed
Momentary & Duress (4 sec)
Short Timed (Button press activates BOTH relays)
Long Timed (Button press activates BOTH relays)
UP/DN + Nudge + Stop
Alternate Latching

This receiver card is compact in size and can be fitted into many gate motor cases or fitted in its own housing as required for the specific site requirements.