Honda Civic 2012 - 2013 72147-TL4-G1 2 button flip key

Honda Civic vehicles from 2012 - 2013 came with a quite different looking flip key with 2 round silver buttons. These new style Honda flip keys keys were quite prone to issues with the key blade breaking away from the flip part. 

The end of Honda Civic from 2012 - 2013 and these models had an integrated flip key with 2 round silver buttons.

This top quality 2 button flip key can be programmed to your Honda Civic vehicle offering a stronger and much more stylish solution to the genuine ones.

The key will be precoded to suit this vehicle and must be programmed to the car using a diagnostic scan tool.

We can do this for you at our East Victoria Park workshop in WA or you can use a licensed locksmith where you live.

This type of key has an integrated ID46 transponder chip on the circuit board and when this is programmed the car the remote part is also programmed at the same time.

There are other very similar looking flip keys for Honda vehicles but the coding on the circuit board and the type of transponder chip is different in each vehicle and so it is vital you check the details of your vehicle matches before ordering.

These flip keys are very good quality and tend to be much stronger than the original plastic headed remote keys that come with the vehicle. The key blade on this flip key folds away and so it does not dig into your leg when the key is in your pocket.

The first image shows a size comparison between the 2 types of key so you can get an idea of the size of the flip key.

The flip key is supplied with a battery fitted and a key blade and roll pin. The key blade will need to be cut to match the vehicle and then it will need to be fitted to the flip key body using the roll pin supplied with it. Any locksmith will be able to do this for you if you are having it done locally where you live.

We only cut Honda keys to factory code using a computerised key cutting machine. Honda locks are quiet complex internally and badly duplicated keys can become jammed in the ignition.

Always check how the locksmith intends to cut your key before proceeding. We decode your original key and ensure that matches to a factory code. This code is then used to cut the new key so it is exactly as the key would have been when the car left the factory. If we cannot decode your key due to excessive wear we will not proceed.

There is a recess on the back of the flip key where you can place a 14mm logo sticker if you wish but please note it is not supplied with one. 

If your original key works but the keyshell is damaged you will find a compatible shell replacement kisted under Compatible Items also.

If you have any questions please feel free to get in touch with us.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing a button cell battery inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body, immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).